weddingferro.blogg.se

1. #HYPERTERMINAL WINDOWS 10 CONNECT CONSOLE SWITCH PC#
2. #HYPERTERMINAL WINDOWS 10 CONNECT CONSOLE SWITCH SERIES#

You can order a kit (part number ACS-DSBUASYN=) that contains the adapter from Cisco. You need to provide an RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal.

#HYPERTERMINAL WINDOWS 10 CONNECT CONSOLE SWITCH PC#

Use the supplied rollover cable and the DB-9 adapter to connect a PC to the switch console port. Conventionsįor more information on document conventions, refer to the Cisco Technical Tips Conventions. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration.

The information in this document was created from the devices in a specific lab environment. To identify the type of cable you use, refer to the document RJ-45 Cables or the Cabling Guide for Console and AUX Ports. Rollover cables and straight-through cables have pinouts that are different than crossover cables, which can connect 10/100BASE-TX Ethernet ports between switches. The cable you use depends on the type of Supervisor Engine and other factors. These switches require the use of either a rollover or straight-through RJ-45 cable to connect a terminal to the console port. There are no specific requirements for this document.

#HYPERTERMINAL WINDOWS 10 CONNECT CONSOLE SWITCH SERIES#

For more information on the use of different connection speeds, cables, or devices, refer to the Multilayer LAN Switches hardware and installation guide for your Catalyst series switch. This document focuses on use of the default parameters to connect and configure management terminals.